Accessory Installation

Dashboard Harness 1 Installation

1. Begin dashboard harness 1 routing under hood.

   

2. Install power connector to Polaris Pulse^® bar.

   

3. Install fuse relay onto firewall.

   

4. Light bar connector routing

   • Rigid^® Light Bars
     Put bullet connectors towards left-side.

     

   • Pro Armor^® Light Bars
     Put bullet connectors towards right-side.

     

5. Put single switch connector through firewall grommet

   

6. Pull switch connector through firewall grommet and pull towards front dashboard.

   

7. Remove blank switch plate.

   

8. Install switch 2 to switch connector.

   

9. Install switch 2 into dashboard and press until it snaps into place.

   

Roll-Cage Adapter Harness 3 Installation

Roll-cage adapter harness 3 is compatible with Pro Armor^® light bars only. Rigid^® light bars use harness supplied with light bar kit.

1. Put fish tape (or equivalent) into opening in roll-cage. Locate fish tape and pull from lower roll-cage opening.

   

2. Tape roll-cage adapter harness 3 (end with bullet connectors) to fish tape and pull through lower roll-cage opening.

   

3. Leave enough excess harness to reach light bar (sold separately) and install attached grommet in roll-cage opening.

   

4. Put connectors, one-by-one, through small cutout in upper fender to reach dashboard harness.

   

5. Install corresponding connectors. Wrap connections with electrical tape.

   

Light Bar Installation

Refer to light bar installation instructions.