Accessory Installation

  1. Remove and retain two fasteners to remove front winch cover.

  2. Place support bracket 4 onto front suspension mount. Pass two fasteners 6 though bracket and mount.

  3. Pass nut-plate 2 through front suspension mount and align with fasteners installed in previous step.

  4. Thread two fasteners 6 into weld nuts 2.

  5. Install front of support bracket with two fasteners 6 and two nuts 8.

    TORQUE

    Mount Fasteners 6:

    40 ft-lbs (54 N·m)

  6. Torque two fasteners 6 to specification.

    TORQUE

    Mount Fasteners 6:

    40 ft-lbs (54 N·m)

  7. Carefully reach through wheel well and hook backer plate 3 onto bumper support.

  8. Ensure backer plate is aligned with holes in bumper support.

    TIP
    Tape hook of backer plate to bumper support to prevent movement when installing bumper.

  9. Reinstall winch cover with two retained fasteners.

  10. Align bumper 1 with upper and lower mounts.

  11. Pass two fasteners 7 through bumper and chassis. Secure fasteners with two nuts 8.

    Do not torque fasteners at this time.

  12. Secure lower bumper with two fasteners 5.

    TORQUE

    Lower Bumper Fasteners 5:

    40 ft-lbs (54 N·m)

  13. Torque two upper bumper fasteners to specification.

    TORQUE

    Upper Bumper Fasteners 7:

    54 ft-lbs (73 N·m)

Parent topic: Installation Instructions