Accessory Installation

  1. Remove and discard top fastener from right and left A-pillar. Retain nut for accessory installation.

  2. Insert accessory fastener 2 and partially thread into accessory nut 4. Do not thread fastener past nut.

  3. With an assistant, lean windshield assembly against vehicle ROPS.

  4. Continue to thread fastener 2 through accessory nut and into lower mounting bracket. Begin to thread retained nut onto end of fastener 2.

    TIP
    Use washer 3 between windshield bracket and accessory nut if windshield fitment is loose.

  5. Continue to thread fastener 2 through accessory nut and into lower mounting bracket. Begin to thread retained nut onto end of fastener 2.

    TIP
    Use washer 3 between windshield bracket and accessory nut if windshield fitment is loose.

  6. Torque two lower mounting fasteners 2 to specification. Retained nuts will be tightened at a later time.

    WARNING
    Failure to torque fasteners as directed will adversely affect ROPS integrity and may lead to severe injury or death in an accident.
    TORQUE

    Lower Mounting Fasteners 2:

    40 ft-lbs (54 N·m)

  7. Secure top of windshield assembly to ROPS brackets with two fasteners 6 and two washers 5.

    TORQUE

    Upper Fasteners 6:

    9 ft-lbs (12 N·m)

  8. Tighten two retained nuts.

    NOTICE
    Ensure nuts are fully tightened for proper windshield fitment. Access to nuts may be difficult.
Parent topic: Installation Instructions