Poly Roof Kit

P/N 2884729

2 Before You Begin

Read these instructions and check to be sure all parts and tools are accounted for. Please retain these installation instructions for future reference and parts ordering information.

3 Kit Contents

Ref

Qty

Part Description

P/N Available Separately

Available Service Kit

1 1 Panel–Roof, Poly 5457311 n/a
2 2 Clamp–Base, Roof n/a 2207824
3 2 Clamp–Hoop, Roof n/a 2207824
4 8 Screw–Torx®, Truss head, #14 x 3/4 in x HI/LO n/a 2208720
5 2 Clamp–Latch, Roof n/a 2207824
6 1 Seal–Clip n/a 2208720
7 2 Clip–U, Speed Nut n/a 2208720
8 2 Screw–Torx® Truss head, M6 x 1.0 x 25 n/a 2208720

4 Tools Required

  • Safety Glasses

  • Socket Set, Torx® Bit

  • Torque Wrench

5 Important

Your is exclusively designed for your vehicle. Please read the installation instructions thoroughly before beginning. Installation is easier if the vehicle is clean and free of debris. For your safety, and to ensure a satisfactory installation, perform all installation steps correctly in the sequence shown.

6 Installation Instructions

6.1 Vehicle Preparation

6.1.1 General

  1. Shift vehicle transmission into PARK.

  2. Turn ignition switch to OFF position and remove key.

6.2 Accessory Installation

Clamp Assembly

  1. Install clamp hoop 3 and clamp latch 5 into clamp base 2.

  2. Test clamp hoop and clamp latch movement to make sure both are fully installed.

Hardware Installation

  1. Install each clamp assembly onto roof panel with four clamp fasteners 4.

    TORQUE

    Clamp Fasteners 4:

    20 in-lbs (2 N·m)

  2. Install two U-clips 7 onto roof panel.

  3. Windshield-equpped vehicles only:
    Install seal 6 onto front of roof panel.

Roof Installation

  1. Hook rear of roof panel onto rear ROPS cross-beam.

  2. Rest clamp assemblies onto front ROPS cross-beam.

  3. Wrap hoops around cross-beam and secure with latch.

  4. Install rear of roof panel with two roof fasteners 8.

    TORQUE

    Rear Roof Fasteners 8:

    96 in-lbs (11 N·m)

7 Instruction Feedback Form

A feedback form has been created for the installer to provide any comments, questions or concerns about the installation instructions. The form is viewable on mobile devices by scanning the QR code or by clicking HERE if viewing on a PC.