Accessory Installation

Steering Wheel Preparation

1. Push left-hand bottom clip and right-hand bottom clip on each side of the rear steering wheel cover. Remove rear steering wheel cover.

   

2. Remove and keep six screws and two bezels from steering wheel.

   

3. Disconnect wiring harness from left-hand A and right-hand B steering controls.

   

4. Remove two wiring harness fir tree clips A and B by pushing them out from the rear of the steering wheel. Discard harness.

Upfitting All S Models

For other models skip to next section.

1. Remove and discard left-hand blank switch module.

2. Put new switch module (from kit P/N 2889164 sold separately) onto steering wheel.

Install New Wiring Harness

1. Install new wiring harness 3. Make sure cable tie clips are secure. Connect left-hand switch module plug 6F and right-hand switch module plug 6F.

   

Installing Paddle Shifters

1. Install retained bezels onto steering wheel. Make sure switch modules are positioned on the steering wheel. Torque fasteners to specification.

   TORQUE

   Switch Module Fasteners:

   6 in-lbs (0.7 N·m)

   

2. Install paddle shifter rear steering wheel cover 4 onto steering wheel. Make sure four clips are in place.

   

3. Make sure wiring harness 3 is routed as shown.

   

4. Insert paddle shifter wire through hole in steering wheel. Put paddle shifter 1 into position.

   

5. Install four paddle shifter screws 5. Torque screws to specification.

   TORQUE

   Paddle Shifter Screws 5:

   10 in-lbs (1 N·m)

   

6. Connect left-hand and right-hand paddle shifter wiring harness to steering wheel harness.

   

Gear Selector Switch Upgrade

1. Refer to Slingshot^® service manual for Gear Selector Switch removal and installation procedure.