Accessory Installation

Amplifier Installation

  1. Install amplifier 1 to amp mount 2 with four fasteners 3. Torque fasteners until fully seated.

  2. Align amp assembly with mounting holes on vehicle frame and install with four fasteners 4. Torque four fasteners to specificaiton.

    TORQUE

    Amp Mount Fasteners 4 (mount to vehicle):

    8 ft-lbs (11 N·m)

Speaker Installation

This section references installation templates found in Front Speaker Templates, P/N 9931497. Measure reference measurements to verify templates are to scale. Cut-out templates along perimeter for use in below procedures.

Right-Hand Speaker

  1. Apply template “Inside RH-1” with tape to passenger foot compartment panel. Drill two marked holes with 15/64 in (6 mm) drill bit.

    IMPORTANT
    Control tool depth. Ensure tool is clear of all other parts and components to prevent damage to vehicle.

  2. Apply template “Inside RH-2” with tape to passenger foot compartment panel. Drill one marked hole with 15/64 in (6 mm) drill bit.

    IMPORTANT
    Control tool depth. Ensure tool is clear of all other parts and components to prevent damage to vehicle.

  3. Remove templates.

  4. Install speaker connector to audio harness connector. Move speaker into installed position and align with drilled holes.

    IMPORTANT
    Make sure harnesses are not pinched between speaker and body panel when speaker is installed.

  5. Install speaker with three fasteners 8 and three washers 7.

    IMPORTANT
    Use caution to not over torque fasteners in speaker assembly.
    TORQUE

    Speaker Fasteners 8:

    26 in-lbs (3 N·m)

Left-Hand Speaker

  1. Apply template “Inside LH-1” with tape to driver foot compartment panel. Drill two marked holes with 15/64 in (6 mm) drill bit.

    IMPORTANT
    Control tool depth. Ensure tool is clear of all other parts and components to prevent damage to vehicle.

  2. Apply template “Inside LH-2” with tape to driver foot compartment panel. Drill one marked hole with 15/64 in (6 mm) drill bit.

    IMPORTANT
    Control tool depth. Ensure tool is clear of all other parts and components to prevent damage to vehicle.

  3. Remove templates.

  4. Install speaker connector to audio harness connector. Move speaker into installed position and align with drilled holes.

    IMPORTANT
    Make sure harnesses are not pinched between speaker and body panel when speaker is installed.

  5. Install speaker with three fasteners 8 and three washers 7.

    IMPORTANT
    Use caution to not over torque fasteners in speaker assembly.
    TORQUE

    Speaker Fasteners 8:

    26 in-lbs (3 N·m)

Ride Command® Mount Kit P/N 2884731

  1. Proceed with Ride Command® Mount Kit, P/N 2884731 installation, if not already equipped. Refer to installation instructions.

Parent topic: Installation Instructions