Accessory Installation
-
Install the retained mounting bracket isolators R into the intake manifold support bracket 1.
NOTICEUse soapy water to help installation.
-
Install the intake manifold support bracket 1 onto the intake manifold and align mounting holes. Install retained washer M and screws L. Torque screws to specification.
TORQUEIntake Manifold Support Bracket Screws L:
88 in-lbs (10 N·m)
-
Install the o-ring 3 into the airbox base 6.
-
Install end of breather hose 4 (without the marking) onto the airbox base 6.
-
Install the airbox gasket 5, throttle body K, airbox base 6, and airbox base screws 12. Torque screws to specification.
NOTICEConnect the end of breather hose (with the marking) onto the breather fitting on the engine when installing airbox base.
TORQUEAirbox Base Screws 12:
88 in-lbs (10 N·m)
-
Put the throttle body wiring in the holder on the throttle body and connect throttle body electrical connector H.
-
Prepare airbox cover surface by wiping clean with Isopropyl alcohol.
WARNINGIsopropyl alcohol is hazardous to your health. See isopropyl alcohol packaging for proper handling instructions, including recommended personal protective equipment such as goggles and chemical resistant gloves. -
Peel backing paper from horn badge 2 and attach to airbox cover 7.
-
Install the airbox gasket 8, airbox cover 7, and airbox cover screws 11. Torque screws to specification.
TORQUEAirbox Cover Screws 11:
88 in-lbs (10 N·m)
-
Install the air filter assembly 9 onto the airbox cover 7. Torque clamp to specification.
TORQUEAir Filter Clamp:
30 in-lbs (3 N·m)
-
Install routing clip 10 to EVAP line and install routing clip to the mounting hole on the backside of the airbox cover.
-
Update ECM with new calibration software using included Calibration Card 14.
IMPORTANTThis step must be completed by an Authorized Indian Motorcycle® Dealer. Do not operate vehicle until recalibration of vehicle is complete.