|
Vehicle Speed |
When standard mode is selected, speed displays
in miles per hour. |
|
When metric mode is selected, speed displays
in kilometers per hour. |
|
Turn Signal / Hazard Signals |
The turn signals are located at the top center
of the instrument cluster. Arrows flash when either a turn signal
or the hazard signal is activated. If a lamp fails, or if there
is a short circuit in the signal system, the lamp flashes at more
than twice the normal rate.
|
|
Low Battery Voltage |
This lamp illuminates when battery voltage
is low (or when voltage is above the normal range). Turn non-essential
accessories off to conserve power. Make sure the charging system is
operating properly. |
|
Over Temperature |
This lamp illuminates to indicate an overheated
engine. If the indicator flashes, the overheating condition remains,
and the system will automatically reduce engine power. |
|
EPS Warning (if equipped) |
This indicator illuminates briefly when the
key is turned to the ON position. If the light remains on, the EPS
system is inoperative. See your POLARIS dealer, or other qualified
person, as soon as possible for repair. Continued operation could
result in permanent damage to the EPS unit and increased steering
effort. |
|
Chassis Warning |
If a fault condition is detected, the light
will remain on as long as the condition exists. Retrieve the error
codes for diagnosis. This lamp is also known as an Amber Warning Lamp
(AWL). |
|
Check Engine |
If this lamp illuminates while the engine
is running, promptly contact an authorized dealer or another qualified
person who can assist with diagnosis. If abnormal engine operation
is detected the light will remain on as long as the fault condition
exists. Retrieve the error codes for diagnosis. See the Error Codes
section for details. This lamp is also known as a malfunction indicator
lamp (MIL). |
|
Seat Belt |
The seat belt lamp illuminates whenever the
vehicle is in ignition state and the driver’s seat belt is
not fastened. |
|
High Beam |
This lamp illuminates when the headlamp switch
is set to high beam. |
|
Low Fuel |
This lamp illuminates when approximately one
gallon (3.8 liters) of fuel remains in the fuel tank. |
|
Trailer Indicator |
The Turn Trailer Indicator is illuminating
when the trailer turn signals are active. |
|
Brake Failure |
This lamp illuminates when brake system (if
Brake Failure Alarm is equipped) detects low fluid level in main brake
hydraulic system. Verify brake fluid in main reservoir at the front
of the vehicle. |
|
PASS (PIN Activated Security System,
if equipped) |
The security indicator lamp illuminates when
the security system is enabled. |
|
Cruise Control Engaged (if equipped) |
Before using the cruise control, read the safety
and operation procedures. |
|
Performance Limited (if equipped) |
Not applicable. |