en
IMPORTANT

The Owner's Manual for this vehicle contains warnings, instructions and other information you must read and fully understand before safely riding or performing maintenance on this vehicle. Always follow the warnings and instructions in Owner's Manual.

Click the link above for the Table Of Contents, or download a full PDF of the Owner Manual in the Owner Support area of Polaris.com.

Belt Installation

NOTICE

Be sure to install belt in the same direction as it was removed.

  1. With the clutch spreader tool 1 installed, loop the belt over the drive clutch and over the driven clutch.

  2. Rotate the driven clutch and walk the belt into the clutch.

  3. Remove the clutch spreader tool from driven clutch.

  4. Rotate / spin the driven clutch and belt approximately 5-7 times to properly seat the belt in the driven clutch.

  5. Install the clutch cover into wheel well as shown above.

  6. Rotate clutch cover over A-Arm 2 as shown below. Use care not to damage intake boots or electrical harness.

  7. Pull clutch cover backwards and align with bolt holes on inner clutch cover as shown below.

  8. Install and torque the outer clutch cover bolts to specification.


    TORQUE

    PVT Outer Cover Fasteners: 35 in-lbs (4 N·m)