en
IMPORTANT

The Owner's Manual for this vehicle contains warnings, instructions and other information you must read and fully understand before safely riding or performing maintenance on this vehicle. Always follow the warnings and instructions in Owner's Manual.

Click the link above for the Table Of Contents, or download a full PDF of the Owner Manual in the Owner Support area of Polaris.com.

Transmission Fluid Level Check

  1. To access the transmission fill plug, remove the plug from the rear lower access panel.

  2. Remove the transmission fill plug located on top of the transmission.

  3. Add 16 oz (0.5 l) of XD STEELDRIVE FLUID to the transmission.

  4. Reinstall oil fill plug with new sealing washer.

    TORQUE

    Transmission Fill Plug:

    15 ft-lbs (21 N·m)

  5. Reinstall the lower access panel plug.

  6. Drive for approximately five minutes or until transmission has reached 104°F (40°C).

  7. Stop on a level surface.

  8. Shift into the Park and leave idling.

  9. With the engine idling, remove the oil level inspection plug from the bottom of the transmission. Allow the oil to drain in a suitable container to be measured later.

  10. Reinstall oil level plug with new sealing washer and shut engine off.

    TORQUE

    Transmission Oil Level Plug:

    15 ft-lbs (21 N·m)

  11. Measure the amount of fluid collected from step 9. If less than 6.8 oz (0.2 l) was collected, add 16 oz (0.5 l) of fluid to the transmission and repeat steps 4 - 9.

  12. Properly dispose of the oil collected.