Accessory Installation

Put front camera 6 into mounting hole, located in grille trim. Clips on camera sides will snap into place when fully seated.

Drill one (19 mm) hole in rear fascia.

Put rear camera harness through hole and push rear camera 5 until it snaps into place.

Reach behind fascia from either side to located chassis electrical harness. Install rear camera to chassis electrical harness.

Detach template page located at the end of this instruction.

Locate REFERENCE DIMENSION on each template page.

Verify REFERENCE DIMENSION is exact and template(s) were printed to proper scale.

Mark three locations on top of hood for alignment pin and antenna mounting post.

Drill at each marked location.

Remove nut from V2V antenna assembly.

Put V2V antenna 10 harness through hole in upper fender panel. Install antenna to upper fender with nut, removed in previous step. Tighten nut until it is fully seated against fender panel.

Align display mount 12 with vehicle frame and install with two fasteners 15.

Install Ride Command^® to display mount with three fasteners16. Torque three fasteners to specification.

Install bezel 14 onto Ride Command^® display.

Remove two nuts from Polaris Pulse^® bar.

Install negative 1F (black) and positive 1F (red) ring terminals with two retained nuts. Torque nuts to specification.

Install fuse relay onto firewall.

Install coaxial connector 1M to V2V antenna.

Put two connectors (front camera and temperature sensor) through opening in radiator shroud, located below right-hand headlight.

Remove cap from front camera connector 4F and install to front camera.

Install temperature sensor connector 2F to air temperature sensor 9. Install harness along winch mount with attached edge clips. Install sensor 9 with attached push-pin.

Put Ride Command^® display and audio connectors through firewall grommet. Attach harness to chassis harness with attached cable tie.

Carefully pull connectors through firewall grommet.

Install the following connectors to the back of the Ride Command^® display.

Put right-hand speaker connector 2F over vehicle frame, between outer fender panel. Connect to speaker, if equipped.

Install subwoofer connector 2F to subwoofer, if equipped.

Install rear audio connector 4M to rear audio harness, if equipped.

Put left-hand speaker connector 2F over vehicle frame, between outer fender panel. Connect to speaker, if equipped.

Install connector 16M to chassis electrical harness.

Install amplifier connector 23F to amplifier, if equipped.

Install USB connector 6F to back of Ride Command^® display.

Open storage bin.

Put USB harness through hole in storage bin and install grommet within hole.

Put antenna mount in upper fender. Antenna mount will snap into place when fully seated.

Remove plastic nut from mounting post.

Put ground strap 7 over mounting post and install with plastic nut removed from mounting post.

Remove and keep one fastener from the firewall.

Install ground strap 7 with retained fastener. Torque fastener until fully seated.

Install antenna mast 4 into antenna mount 11.

Put antenna mount ring connector 1F over mounting post and install with nut 17.

Put antenna connector 1F through firewall grommet.

Pull antenna connector from firewall grommet towards Ride Command^® display.

Install antenna connector 1F to Ride Command^® display.