Accessory Installation

IMPORTANT
Protect all finished and painted surfaces during these operations.

Install Catalytic Converter Heat Shield

  1. Open and insert a new worm-drive clamp 1 on the accessory catalytic converter heat shield 2 as shown.

  2. Open the worm-drive clamp far enough to slip it over the exhaust pipe, and then put the accessory catalytic converter heat shield 2 on the motorcycle.

  3. Install the two heat shield fasteners E and torque to specification.

    TORQUE

    Heat Shield Fasteners E:

    88 in-lbs (10 Nm)

  4. Torque the worm-drive clamp to specification.

    TORQUE

    Worm-Drive Clamp 1:

    31 in-lbs (3.4 Nm)

Install Front Heat Shield

  1. Open and insert three new worm-drive clamps 1 on the accessory front heat shield 4 as shown.

  2. Open the worm-drive clamps far enough to slip them over the exhaust pipe, and then put the accessory front heat shield 4 on the motorcycle. Make sure the clamps are set as shown.

  3. Make sure the seams between the heat shields are aligned, and then torque the worm-drive clamps to specification.

    TORQUE

    Worm-Drive Clamp 1:

    31 in-lbs (3.4 Nm)

Install Rear Heat Shield

  1. Open and insert two new worm-drive clamps 1 on the accessory rear heat shield 3 as shown.

  2. Open the worm-drive clamps far enough to slip them over the exhaust pipe, and then put the accessory rear heat shield 3 on the motorcycle.

  3. Make sure the seams between the heat shields are aligned, and then torque the worm-drive clamps to specification.

    TORQUE

    Worm-Drive Clamp 1:

    31 in-lbs (3.4 Nm)
Parent topic: Installation Instructions