en
IMPORTANT

The Owner's Manual for this vehicle contains warnings, instructions and other information you must read and fully understand before safely riding or performing maintenance on this vehicle. Always follow the warnings and instructions in Owner's Manual.

Click the link above for the Table Of Contents, or download a full PDF of the Owner Manual in the Owner Support area of Polaris.com.

Drive Chain Adjustment

Lubricate the drive chain with INDIAN MOTORCYCLE chain spray lube or an approved chain lube at the interval specified in the Periodic Maintenance Chart. Lubricate more often under severe use, such as dirty or wet conditions.

IMPORTANT
Washing the drive chain with a high pressure washer or solvents can cause premature wear and chain failure. Do not use a high pressure washer or gasoline to clean the drive chain. Operating the motorcycle with improper rear drive chain deflection can result in severe damage to the transmission and drive components. Always make sure the chain is adjusted within the stated specifications.
WARNING

A rear axle not in alignment can cause drive line noise and damage the drive chain, causing possible chain failure and loss of control of the motorcycle.

  1. Loosen the axle nut 1.

  2. Loosen both tension bolt jam nuts 2 on both sides.

  3. Adjust the tension bolts 3 evenly on both sides until correct tension is achieved. Reference Drive Chain Tension - Specifications.

    IMPORTANT

    To minimize change in chain tension, use RIGHT SIDE adjuster only to make final adjustments to chain alignment. Be sure to keep axle seated forward against axle adjusters during this procedure.

  4. Use the adjuster marks to ensure even axle alignment.

  5. Without moving the tension bolts, Tighten jam nuts. Ensure the axle is pushed forward against the adjuster bolts.

    TORQUE

    Swing Arm Jam Nut

    12 in-lbs (1.36 N·m)

  6. Recheck chain tension and adjust accordingly.

  7. Install axle nut.

    TORQUE

    Axle Nut (Rear)

    92 ft-lbs (125 N·m)