en
IMPORTANT

The Owner's Manual for this vehicle contains warnings, instructions and other information you must read and fully understand before safely riding or performing maintenance on this vehicle. Always follow the warnings and instructions in Owner's Manual.

Click the link above for the Table Of Contents, or download a full PDF of the Owner Manual in the Owner Support area of Polaris.com.

Radiator Coolant Level / Changing Coolant

This procedure is required only if the cooling system has been drained for maintenance and/or repair. If the overflow bottle 3 has run dry, the level in the radiator should also be inspected.

CAUTION
Escaping steam can cause burns. Never remove the pressure cap while the engine is warm or hot. Always allow the engine to cool before removing the pressure cap.

  1. Remove the hood. See the Hood section for details.

  2. Slowly remove the radiator pressure cap 2.

  3. View the coolant level through the opening.

  4. Use a funnel and slowly add coolant as needed.

  5. Before reinstalling the pressure cap, bleed the system of trapped air. Remove the engine access panel behind the seats and use a flat-blade screwdriver to turn the bleed screw 1 slightly, allowing the air to escape. Slowly add additional coolant to the radiator until air no longer escapes and only coolant flows from the bleed hole, then tighten the bleed screw.

  6. Reinstall the pressure cap.
TIP
Use of a non-standard pressure cap will not allow the recovery system to function properly. See your dealer for the correct replacement part.
Parent topic: Cooling System