Oil and Filter Change

Always change the oil and filter at the intervals outlined in the Periodic Maintenance Chart section. Always change the oil filter 1 whenever changing oil.

Access the oil check dipstick and oil filter through the engine access panel located behind the seats.

The crankcase drain plug is located on the bottom of the crankcase. Access the drain plug through the access hole under the crankcase.

1. Position the vehicle on a level surface. Place the transmission in PARK.

2. Clean the area around the crankcase drain plug.

   CAUTION

   Hot oil can cause burns to skin. Do not allow hot oil to contact skin.

3. Place a drain pan under the engine crankcase and remove the drain plug. Allow the oil to drain completely.

4. Remove the seats and remove the engine access panel.

5. Using an oil filter wrench, turn the filter 1 counterclockwise to remove it.

6. Using a clean dry cloth, clean the filter sealing surface on the crankcase.

7. Lubricate the o-ring on the new filter with a film of fresh engine oil. Check to make sure the o-ring is in good condition.

8. Install the new filter and turn by hand until the filter gasket contacts the sealing surface, then turn an additional 3/4 turn.

9. Reinstall the crankcase drain plug. Torque to 12 ft-lbs (16 N·m).

10. Remove the oil fill cap and add 2.5 qt (2.4 l) of recommended oil (listed in the Oil Recommendations section). Reinstall the fill cap.

11. Start the engine and check for leaks.

12. Stop the engine and wait 15 seconds before removing the dipstick.

13. Remove the dipstick. Wipe it dry with a clean cloth.

14. Reinstall the dipstick completely. Remove the dipstick and check the oil level.

15. Add oil as necessary to bring the level to the upper mark on the dipstick. Do not overfill.

16. Reinstall the dipstick.

17. Reinstall the oil fill cap.

18. Dispose of used filter and oil properly.