en
IMPORTANT

The Owner's Manual for this vehicle contains warnings, instructions and other information you must read and fully understand before safely riding or performing maintenance on this vehicle. Always follow the warnings and instructions in Owner's Manual.

Click the link above for the Table Of Contents, or download a full PDF of the Owner Manual in the Owner Support area of Polaris.com.

Spark Arrestor

WARNING
Failure to heed the following warnings while servicing the spark arrestor could result in serious injury or death.

  • Never run the engine in an enclosed area. Exhaust contains poisonous carbon monoxide gas that can cause loss of consciousness or death in a very short time.

  • Wear eye protection and leather work gloves.

  • Do not perform clean-out immediately after the engine has been run, as the exhaust system becomes very hot. Serious burns could result from contact with the exhaust components. Allow components to cool sufficiently before proceeding.

Never operate without the spark arrestor

Periodically clean the spark arrestor to remove accumulated carbon.

  1. Place the transmission in PARK.

  2. Remove the arrestor retaining bolt and nut.

  3. Remove the arrestor from the end of the muffler.

  4. Use non-synthetic brush to clean the arrestor screen. A synthetic brush may melt if the components are warm. If necessary, blow debris from the screen with compressed air.

  5. Inspect the screen for wear and damage. Replace a worn or damaged screen.

  6. Reinstall the arrestor.

  7. Torque the bolt to specification.

    TORQUE

    Spark Arrestor Fastener:

    8 ft-lbs (11 N·m)