Low Beam Adjustment
-
Place the vehicle on a level surface with the headlight approximately 25 ft. (7.6 m) from a wall.
NOTICERider weight must be included on the seat while performing this procedure.
-
Place the transmission in PARK.
-
Measure the distance from the floor to the center of the headlight and make a mark on the wall at the same height.
-
Start the engine and turn the headlight switch to high beam.
-
Observe the headlight aim on the wall. The most intense part of the headlight beam should be aimed 2 in. (5 cm) below the mark placed on the wall in Step 3.
-
Open the front rack.
-
Adjust the beam to desired position and tightening or loosening the screws at the top of the lights. Adjust each light independently.
WARNINGDue to the nature of ATVs and where they are operated, headlight lenses become dirty. Frequent washing is necessary to maintain lighting quality. Riding with poor lighting can result in severe injury or death.