en
IMPORTANT

The Owner's Manual for this vehicle contains warnings, instructions and other information you must read and fully understand before safely riding or performing maintenance on this vehicle. Always follow the warnings and instructions in Owner's Manual.

Click the link above for the Table Of Contents, or download a full PDF of the Owner Manual in the Owner Support area of Polaris.com.

Rear Gearcase Oil

Always check and change the rear gearcase oil at the intervals outlined in the Maintenance Interval Chart. See the Lubrication Guide section for fluid recommendations, capacities, and plug torques.

The fill plug is located on the rear of the gearcase. The drain plug is located on the bottom of the gearcase.

Maintain the fluid level at the bottom of the fill hole threads. Do not overfill.

OIL CHECK

  1. Position the vehicle on a level surface.

  2. Remove the fill plug 1. Check the oil level.

  3. Add the recommended oil as needed to bring the level to the bottom of the fill hole threads. Do not overfill.

  4. Reinstall the fill plug. Torque to specification.

TORQUE

Fill Plug:

12 ft-lbs (16 N·m)

OIL CHANGE

  1. Position the vehicle on a level surface.

  2. Place a drain pan under the drain hole 2.

  3. Remove the drain plug. Allow the oil to drain completely.

  4. Clean and reinstall the drain plug with a new sealing washer. Torque to specification.

    TORQUE

    Drain Plug:

    12 ft-lbs (16 N·m)

  5. Remove the fill plug. Add the proper amount of the recommended oil. Do not overfill.

    CAPACITY
    Recommended Lubricant:

    Polaris ATV Angle Drive Fluid

    Capacity:

    Add fluid until it is visible at the fill hole threads (approximately 7.9 floz (235 ml))

  6. Reinstall the fill plug. Torque to specification.

    TORQUE

    Fill Plug:

    12 ft-lbs (16 N·m)

  7. Check for leaks.

  8. Dispose of used oil properly.