Oil Change
- 
                  
                  Position the vehicle on a level surface. Set the parking brake. 
- 
                  
                  Clean the area around the drain plug 1. 
- 
                  
                  Start the engine. Allow it to idle for 30 seconds. 
- 
                  
                  Stop the engine. 
             
            
- 
                  
                  Place a drain pan under the engine crankcase. 
- 
                  
                  Remove the drain plug and pre-filter screen 2. Allow the oil to drain completely. 
- 
                  
                  Wash the oil pre-filter screen with solvent to remove debris. Allow the screen to air dry. 
- 
                  
                  The external oil filter and oil cooler 3 are mounted to the chassis under the engine. The oil filter is accessible on the right side of the vehicle. The spin-on oil filter should be replaced when oil is changed. With the oil drained from the crankcase, unscrew the oil filter and replace with a new one. Ensure that the oil filter gasket is properly seated, lubricated with oil and in good condition. Do not over tighten the oil filter. TORQUEExternal Oil Filter: Turn by hand until filter O-ring contacts sealing surface, then turn an additional 3/4 turn. 
- 
                  
                  Reassemble the pre-filter screen and spring to the pre-filter plug. 
- 
                  
                  Reinstall the drain plug and tighten to specification. 
             
            
Drain Plug:
10 ft-lbs (14 N·m)
- 
                  
                  Remove the dipstick. Add 35.5 floz (1050 ml) of the recommended oil. Do not overfill. See the specifications section for capacities. 
- 
                  
                  Reinstall the dipstick. 
- 
                  
                  Start the engine. Allow it to idle for 30 seconds. 
- 
                  
                  Stop the engine and inspect for leaks. 
- 
                  
                  Wait at least 15 seconds before removing the oil dipstick. Check the oil level. 
- 
                  
                  Add oil as needed to bring the level to the upper mark on the dipstick. 
- 
                  
                  Dispose of used oil properly.