en
IMPORTANT

The Owner's Manual for this vehicle contains warnings, instructions and other information you must read and fully understand before safely riding or performing maintenance on this vehicle. Always follow the warnings and instructions in Owner's Manual.

Click the link above for the Table Of Contents, or download a full PDF of the Owner Manual in the Owner Support area of Polaris.com.

Left Hand Control Alignment

The following procedure details how to properly align the left hand control block.

IMPORTANT
Take care to avoid damaging hand warmer/brake switch wires when moving components.

  1. Loosen the brake master cylinder 1 mounting screws and move it away from the left hand control.

  2. Loosen the four left hand control mounting screws.

  3. Move the control block to the desired position.

    NOTICE
    If the control is loose and was inadvertently moved without loosening the screws, move the control block slightly to the left or right to relocate the pins.

  4. Tighten the screws to specification in the sequence shown in the image. Do not over-torque.

TORQUE

Control Block Mounting Screws 2 - 5

24 in-lbs (2.7 N·m)

  1. Return the master cylinder to its specified position. Make sure the clamp will not pinch the brake light signal wire. Tighten the mounting screws 1 to specification beginning with the front screw first, then the screw next to reservoir. Do not over-torque.

    TORQUE

    Master Brake Cylinder Mounting Screws 1

    70 in-lbs (7.9 N·m)

Parent topic: Handle Bar Examples