Adjustable Headlight
The headlight can be adjusted for vertical aim using the following procedure.
-
In a well-ventilated area, position the snowmobile on a level surface with the headlight approximately 25 feet (7.6 m) from a wall 1.
-
Place the rider or the approximate weight of the rider on the seat or tunnel floorboards.
-
Measure the distance from the floor to the center of the headlight and make a mark on the wall at the same height.
-
Start the engine. Move the headlight switch to high beam.
-
Observe the headlight aim on the wall. The most intense part of the headlight beam should be two inches (5 cm) 2 below the mark on the wall.
-
If adjustment is necessary, access the headlight adjuster knob through the left side panel. Turn the adjuster knob clockwise to lower the beam. Turn the adjuster counter-clockwise to raise the beam.