en
IMPORTANT

The Owner's Manual for this vehicle contains warnings, instructions and other information you must read and fully understand before safely riding or performing maintenance on this vehicle. Always follow the warnings and instructions in Owner's Manual.

Click the link above for the Table Of Contents, or download a full PDF of the Owner Manual in the Owner Support area of Polaris.com.

Polaris Maintenance Schedule

The intervals shown in this table are based on vehicles operated under normal conditions.

Each interval is given in hours and miles (kilometers). Items should be serviced at whichever interval comes first.

Continue to reference the following maintenance schedules at the given intervals as hours and miles (kilometers) increase on the vehicle.

Vehicles subjected to severe use must be serviced at 50% of the stated interval. Examples of Severe Use: Frequent immersion in mud, water, or sand, constant high RPM use, prolonged low-speed heavy load operation, extended idle, and short trip cold weather operation.

Initial Break-In Service
First 25 Hours / 500 Miles (800 km)
Brake System Initial fluid level inspection; inspect for fluid leaks; add lubricant if needed. Inspect brake pad wear.
Engine Oil and Filter Change the engine oil and filter.
Front Gearcase Fluid Initial fluid level inspection.
Transmission Fluid Initial fluid level inspection; inspect for fluid leaks; add lubricant if needed.
The break-in period consists of the first 25 hours of operation. Careful treatment of a new engine and drive components will result in more efficient performance and longer life for these components. The items outlined in this service interval only need to be performed at the first 25 hours of operation. They do not need to be performed every 25 hours.

Vehicles subjected to severe use must be serviced at 50% of the stated interval. Examples of Severe Use: Frequent immersion in mud, water, or sand, constant high RPM use, prolonged low-speed heavy load operation, extended idle, and short trip cold weather operation.

Every 50 Hours / 500 Miles (800 km)
Brake Pad Wear Inspect; replace as needed.
General Lubrication Locate all applicable fittings and grease.
Engine Breather Inspect; clean as needed.

Vehicles subjected to severe use must be serviced at 50% of the stated interval. Examples of Severe Use: Frequent immersion in mud, water, or sand, constant high RPM use, prolonged low-speed heavy load operation, extended idle, and short trip cold weather operation.

Every 100 Hours / 1000 Miles (1600 km) or Yearly
Air Filter Replace air filter. Ensure proper installation of filter and airbox cover. Inspect ducts and screens; clean as necessary.
Battery Check terminals; terminals should be tight and free of corrosion. Clean, test, and replace as necessary.
Brake Pad Wear Inspect; replace as needed.
Clutches* Inspect bushings, rollers, wearable parts; clean; replace worn parts. Inspect drive belt.
Cooling System Fluid level inspection; inspect for fluid leaks; add coolant if needed. Inspect coolant strength seasonally; pressure test system yearly.
Drive Belt Inspect; replace as needed.
Engine Breather Inspect; clean as needed.
Engine Oil and Filter Change the engine oil and filter.
Exhaust Silencer / Pipe Inspect for leaks or damage.
Front Gearcase Fluid Change fluid.
Front / Rear Suspension Lubricate (if applicable).
Fuel System* Cycle key to pressurize fuel pump; check for leaks at fuel system connections, check for leaks at fill cap.
General Lubrication Locate all applicable fittings and grease.
Parking Brake (if applicable)* Inspect and adjust as needed.
Spark Arrestor Clean out.
Spark Plugs Inspect; replace as needed.
Suspension Components* Inspect tie rods, wheel bearings, suspension bushings, and ball joints for loose or worn components; replace as needed. Inspect shock absorbers for leaks or damage.
Transmission Fluid Change fluid.
Wiring Inspect for wear, routing, and retention.
* It is recommended to have an authorized Polaris dealer perform these services.

Vehicles subjected to severe use must be serviced at 50% of the stated interval. Examples of Severe Use: Frequent immersion in mud, water, or sand, constant high RPM use, prolonged low-speed heavy load operation, extended idle, and short trip cold weather operation.

Additional Maintenance Intervals

Every 200 hours / 2000 miles (3200 km)

 Shock Absorbers* Change shock oil or rebuild (if applicable). Inspect seals and replace as needed.

Every 310 hours / 3100 miles (5000 km)

 Valve Clearance* Inspect; adjust as needed.

Every 24 months / 2 years

 Brake Fluid Change fluid.

Every 60 months / 5 years

 Coolant Change fluid.
* It is recommended to have an authorized Polaris dealer perform these services.