Optional Rear Suspension Mounting Holes
IMPORTANT
Every hole position must match on both sides
of the vehicle. Do not mix A and B positions. If mixing of A and B
hole positions occurs, the rear suspension will not function properly
and damage may occur.
Your vehicle is equipped with optional rear suspension mounting holes. The factory installed and preferred setting is the A position. If a drastic reduction in ski pressure is desired, you can move the labeled geometry points to the B position. The 6 adjustable points are as follows:
-
1 Torsion Spring Hanger Hole
-
2 Front Coupling Block Hole
-
3 Lower Rear Pivot Arm Hole
-
4 Rear Coupling Block Hole
-
5 Front Tunnel Torque Arm Hole
-
6 Rear Tunnel Torque Arm Hole
