en
IMPORTANT

The Owner's Manual for this vehicle contains warnings, instructions and other information you must read and fully understand before safely riding or performing maintenance on this vehicle. Always follow the warnings and instructions in Owner's Manual.

Click the link above for the Table Of Contents, or download a full PDF of the Owner Manual in the Owner Support area of Polaris.com.

Engine Oil and Filter Replacement

Always change engine oil and filter at the intervals outlined in the Periodic Maintenance Chart. Always change the oil filter1 whenever changing the engine oil.

The engine oil dipstick is located on the right front side of the engine. The engine oil fill cap is located on top of the valve cover. Access the oil dipstick and oil fill cap by tilting the rear cargo box.

The crankcase drain plug2 is located on the bottom of the crankcase. Access the drain plug through the skid plate access hole located directly under the crankcase.

  1. Position vehicle on a level surface and place the transmission in PARK.

  2. Stop the engine and allow it to cool down.

  3. Clean the area around the crankcase drain plug.

    CAUTION

    Use caution when performing this procedure. Do not allow hot engine oil to come into contact with skin, as serious burns may result.

  4. Place a drain pan under the engine crankcase and remove the drain plug. Allow the oil to drain completely.

  5. Remove all cargo from the cargo box.

    CAUTION

    Always remove all cargo from the cargo box before lifting the box to access the engine.

  6. Pull up on the cargo box release lever to tilt the box.

  7. Using the Oil Filter Wrench, turn the oil filter 2 counter-clockwise to remove it.

  8. Using a clean dry cloth, clean the filter sealing surface on the engine crankcase.

  9. Lubricate the O-ring on the new oil filter with a film of fresh engine oil. Check to make sure the O-ring is in good condition. Install it to specification.

    TORQUE

    Oil Filter

    Turn by hand until filter O-ring contacts sealing surface, then turn an additional 3/4 turn.

  10. Replace the sealing washer on drain plug.

    NOTICE

    The sealing surface on the drain plug should be clean and free of burrs, nicks or scratches.

  11. Reinstall the engine crankcase drain plug. Torque drain plug to specification.

    TORQUE

    Crankcase Drain Plug

    12 ft–lbs (16 N⋅m)

  12. Remove oil fill cap. Fill engine with recommended engine oil.

  13. Verify the transmission is still in PARK.

  14. Start the engine and allow it to idle for 30 seconds.

  15. Stop the engine and inspect for oil leaks. Wait at least 15 seconds before removing the dipstick.

  16. Unlock the dipstick lever 3. Remove the dipstick and wipe it dry with a clean cloth.

    NOTICE
    The dipstick is located on the right side of the vehicle.

  17. Reinstall the dipstick and push it into place. Do not lock the dipstick.

    NOTICE

    Make certain the dipstick is inserted all the way into the dipstick tube to keep the depth of the dipstick consistent.

  18. Remove the dipstick and check the oil level.

  19. Add the recommended oil as necessary to bring the oil level within the SAFE range on dipstick. Do not overfill.

  20. When finished, reinstall the oil fill cap, oil dipstick and lock the lever.

  21. Dispose of used oil and filter properly.

Parent topic: Engine Oil