en
IMPORTANT

The Owner's Manual for this vehicle contains warnings, instructions and other information you must read and fully understand before safely riding or performing maintenance on this vehicle. Always follow the warnings and instructions in Owner's Manual.

Click the link above for the Table Of Contents, or download a full PDF of the Owner Manual in the Owner Support area of Polaris.com.

Polaris Maintenance Schedule - SP 570 / SP 570 Premium Models

The intervals shown are based on vehicles operated under normal conditions.

Each interval is given in hours and miles (kilometers). Items should be serviced at whichever interval comes first.

Continue to reference the following maintenance schedules at the given intervals as hours and miles (kilometers) increase on the vehicle.

Vehicles subjected to severe use must be serviced at 50% of the stated interval. Examples of Severe Use: Frequent immersion in mud, water, or sand, constant high RPM use, prolonged low-speed heavy load operation, extended idle, and short trip cold weather operation.

Initial Break-In Service
First 25 Hours
Engine Oil and Filter Change the engine oil and filter.
The break-in period consists of the first 25 hours of operation. Careful treatment of a new engine and drive components will result in more efficient performance and longer life for these components. The items outlined in this service interval only need to be performed at the first 25 hours of operation. They do not need to be performed every 25 hours.

Vehicles subjected to severe use must be serviced at 50% of the stated interval. Examples of Severe Use: Frequent immersion in mud, water, or sand, constant high RPM use, prolonged low-speed heavy load operation, extended idle, and short trip cold weather operation.

Every 25 Hours / 250 Miles (400 km)
Engine Breather Inspect; replace as needed.

Vehicles subjected to severe use must be serviced at 50% of the stated interval. Examples of Severe Use: Frequent immersion in mud, water, or sand, constant high RPM use, prolonged low-speed heavy load operation, extended idle, and short trip cold weather operation.

Every 50 Hours / 500 Miles (800 km)
Battery Check terminals; terminals should be tight and free of corrosion. Clean, test, and replace as necessary.
Brake System Inspect fluid level; inspect for fluid leaks; add recommended brake fluid from a sealed container if needed. Inspect brake pad wear.
Drive Belt Inspect; replace as needed.
Engine Breather Inspect; replace as needed.
General Lubrication Locate all applicable fittings and grease.
Throttle Body / Air Intake Ducts / Flanges Inspect duct for proper sealing/air leaks.
Every 100 Hours / 1000 Miles (1600 km) or Yearly
Battery Check terminals; terminals should be tight and free of corrosion. Clean, test, and replace as necessary.
Brake System Inspect fluid level; inspect for fluid leaks; add recommended brake fluid from a sealed container if needed. Inspect brake pad wear.
Cooling System Inspect fluid level; inspect for fluid leaks; add coolant if needed. Inspect coolant strength seasonally; pressure test system yearly.
Drive Belt Inspect; replace as needed.
Engine Breather Inspect; clean as needed.
Engine Oil and Filter Change the engine oil and filter.
Exhaust Silencer / Pipe Inspect for leaks or damage.
Front Gearcase Fluid Change fluid.
Fuel System* Cycle key to pressurize fuel pump; check for leaks at fuel system connections, check for leaks at fill cap. Check for signs of wear on fuel lines.
General Lubrication Locate all applicable fittings and grease.
Parking Brake (if applicable)* Inspect and adjust as needed.
PVT* Inspect bushings, rollers, wearable parts; clean; replace worn parts.
Spark Arrestor Clean out. Inspect after every ride where submerged in mud.
Spark Plug Replace as needed.
Suspension Components* Inspect tie rods, wheel bearings, suspension bushings, and ball joints for loose or worn components; replace as needed. Inspect shock absorbers for leaks or damage.
Transmission Fluid Change fluid.
Throttle Body / Air Intake Ducts / Flanges Inspect duct for proper sealing/air leaks.
Wiring Inspect for wear, routing, and retention.
* Have an authorized Polaris dealer or other qualified person perform these services.

Vehicles subjected to severe use must be serviced at 50% of the stated interval. Examples of Severe Use: Frequent immersion in mud, water, or sand, constant high RPM use, prolonged low-speed heavy load operation, extended idle, and short trip cold weather operation.

Additional Maintenance Intervals

Weekly

 Air Filter Inspect and replace as needed.

Every 250 hours / 2500 miles (4000 km)

 Shock Absorbers* Replace as needed.

Every 500 hours / 5000 miles (8000 km)

 Valve Clearance* Inspect; adjust as needed.

Every 24 months / 2 years

 Brake Fluid Change fluid.

Every 60 months / 5 years

 Coolant Change fluid.
* Have an authorized Polaris dealer or other qualified person perform these services.