Oil and Filter Change

Always check and change the oil at the intervals outlined in the Polaris Maintenance Schedule section. Always change the oil filter whenever changing oil.

The engine drain plug 1 is located on the bottom of the crankcase. Use a 6mm hex bit socket or equivalent.

1. Position the vehicle on a level surface. Place the transmission in PARK. Apply the brakes.

2. Start the engine. Allow it to idle for two to three minutes. Stop the engine.

3. Clean the area around the drain plug.

   CAUTION

   Hot oil can cause burns to skin. Do not allow hot oil to contact skin.

4. Place a drain pan beneath engine crankcase and remove the drain plug 1.

   

5. Allow the oil to drain completely.

6. Install a new sealing washer 2 on the drain plug.

   TIP

   The sealing surfaces on drain plug and crankcase should be clean and free of burrs, nicks or scratches.

7. Reinstall the drain plug.

   TORQUE

   12 ft-lbs (16 Nm )

8. Using a cap-style oil filter wrench or equivalent, turn the filter 3 counter-clockwise to remove it.

   

9. Using a clean dry cloth, clean the filter sealing surface on the crankcase. Make sure the old filter o-ring is completely removed.

10. Lubricate the o-ring on the new filter with a film of fresh engine oil. Check to make sure the o- ring is in good condition.

11. Install the new filter and turn by hand until the filter gasket contacts the sealing surface, then turn an additional 3/4 turn.

12. Always clean away all dirt and debris from the dipstick area before removing the dipstick.

    

13. Remove the dipstick 5 and check the oil level.

14. Add the recommended fluid as needed. Maintain the oil level in the safe range between the FULL 2 and ADD 3 marks. Do not overfill.

    
    CAPACITY

    Recommended Lubricant:

    Polaris PS-4 5W-50 Full Synthetic 4–Cycle Engine Oil

    Capacity:

    1.9 L (2 qt)

15. Reinstall and tighten the dipstick. Reinstall upper oil cap (if removed).

16. Make sure the transmission is in PARK. Apply the brakes.

17. Start the engine. Allow it to idle for one to two minutes.

18. Stop the engine. Inspect for leaks.

19. Re-check the oil level on the dipstick and add oil as necessary to bring the level to the upper mark on the dipstick.

20. Dispose of used filter and oil properly.