en
IMPORTANT

The Owner's Manual for this vehicle contains warnings, instructions and other information you must read and fully understand before safely riding or performing maintenance on this vehicle. Always follow the warnings and instructions in Owner's Manual.

Click the link above for the Table Of Contents, or download a full PDF of the Owner Manual in the Owner Support area of Polaris.com.

High Beam Adjustment

The headlight beam can be adjusted slightly upward or downward. Use the following procedure to make the adjustment.

  1. Position the vehicle on a level surface with the headlight approximately 7.6 m from a wall 1.

  2. Place the transmission in PARK.

  3. Measure the distance from the floor to the center of the headlight and make a mark on the wall at the same height.

  4. Start the engine. Turn the headlight switch to high beam.

  5. Observe the headlight aim on the wall. The most intense part of the headlight beam should be 5 cm below the mark on the wall2. Include rider weight on the seat when measuring.

  6. If adjustment is needed, the adjustment screw 1 is located on the right side of the headlight pod. To adjust the beam, loosen the screw. Adjust the headlamp to the desired position, then tighten the screw.