en
IMPORTANT

The Owner's Manual for this vehicle contains warnings, instructions and other information you must read and fully understand before safely riding or performing maintenance on this vehicle. Always follow the warnings and instructions in Owner's Manual.

Click the link above for the Table Of Contents, or download a full PDF of the Owner Manual in the Owner Support area of Polaris.com.

Low Beam Adjustment

To adjust the front headlights, do the following:

  1. Place the vehicle on a level surface with the headlight approximately 23 ft (7 m) from a wall.

    NOTICE

    Rider weight must be included on the seat while performing this procedure.

  2. Place the transmission in PARK.

  3. Measure the distance from the floor to the center of the headlight and make a mark on the wall at the same height.

  4. Turn ignition ON and switch the headlight to low beam.

  5. Observe the headlight aim on the wall. The horizontal line, separating the lit-zone from the unlit-zone, should be aimed 8 in (20 cm) below the mark placed on the wall in step 3.

  6. Open the front rack.

  7. If adjustment is needed, use the torx wrench tool included in the vehicle’s tool kit to adjust the headlight adjustment fasteners. Keep the most intense part of the headlight beam in the middle. When the lights are adjusted insert the compartment plug and close the front rack.

    WARNING

    Due to the nature of ATVs and where they are operated, headlight lenses can become dirty. Frequent washing is necessary to maintain lighting quality. Riding with poor lighting can result in severe injury or death.