en
IMPORTANT

The Owner's Manual for this vehicle contains warnings, instructions and other information you must read and fully understand before safely riding or performing maintenance on this vehicle. Always follow the warnings and instructions in Owner's Manual.

Click the link above for the Table Of Contents, or download a full PDF of the Owner Manual in the Owner Support area of Polaris.com.

Soft-Top Installation

NOTE
Make sure screen printing faces inward as shown.

1. Remove top from it’s protective storage case. Leave the top rolled up.

2. Insert semi-rigid front edge of top into the channel at the front of the frame assembly.

3. Slide the semi-rigid front edge into the channel. Make sure the top is centered in the channel by matching the overhang amount on each side.

4. Route the top over the front of the frame assembly and unroll toward the rear of the vehicle. Make sure the top remains evenly spaces on the frame assembly.

5. Fasten the two rear buckles A around the rear of the frame assembly.

6. Fasten the four side buckles B.

7. Feed center strap C through welded loop on frame assembly, then through attached ring. Loosely fasten using hook and loop material.

8. Make sure top is centered on frame assembly. Gradually tighten rear and side buckles, making sure top stays centered.

9. When six buckles are tight, tighten center strap.
Parent topic: Soft-Top (if equipped)