en
IMPORTANT

The Owner's Manual for this vehicle contains warnings, instructions and other information you must read and fully understand before safely riding or performing maintenance on this vehicle. Always follow the warnings and instructions in Owner's Manual.

Click the link above for the Table Of Contents, or download a full PDF of the Owner Manual in the Owner Support area of Polaris.com.

Front Gearcase

Always check and change the fluid at the intervals outlined in the Periodic Maintenance Chart section. Refer to the Gearcase Specifications Chart for recommended lubricants, capacities and torque specifications.

Fluid Check

The fill plug 1 is located on the bottom right side of the front drive unit. Maintain recommended fluid volume (listed in the Gearcase Specification Chart).

  1. Position the vehicle on a level surface.

  2. Remove the fill plug using an 8 mm Allen wrench.

  3. Check the fluid level. The fluid should be even with the bottom of the fill plug hole.

  4. If necessary, add the recommended fluid (listed in the Gearcase Specification Chart). Do not overfill.

  1. Reinstall the fill plug. Torque to specification.

    TORQUE

    Fill Plug Torque:

    10–14 ft-lbs (14–19 Nm)
  2. Clean any fluid residue from around the fill plug.

Fluid Change

The front drive drain plug 2 is located on the bottom of the gearcase.

  1. Position the vehicle on a level surface.

  2. Remove the fill plug using an 8 mm Allen wrench.

  3. Place a drain pan under the drain plug.

  4. Remove the drain plug.

  5. Clean the drain plug.

  1. Reinstall the drain plug. Torque to specification.

    TORQUE

    Drain Plug Torque:

    10–14 ft-lbs (14–19 Nm)
  2. Add the recommended fluid (listed in the Gearcase Specification Chart) through the fill plug hole until the fluid is even with the bottom of the fill plug hole.

  3. Reinstall the fill plug. Torque to specification.

    TORQUE

    Fill Plug Torque:

    10–14 ft-lbs (14–19 Nm)

  4. Clean any fluid residue from around the drain and fill plugs.

  5. Dispose used fluid properly.