Work Light Adjustment
The work light beam can be adjusted slightly upward or downward. Use the following procedure to make the adjustment.
Image is for reference only. Your model might differ slightly.
-
Ensure the tire pressure of each tire is at the recommended level.
-
Position the vehicle on a level surface with the work light approximately 25 ft (7.6 m) from a wall 1. Place the transmission in PARK (P).
-
Measure the distance from the floor to the center of the work light and make a mark on the wall at the same height.
-
Start the engine. Turn on the work light.
-
Observe the work light aim on the wall. The most intense part of the work light beam should be 2 in (5 cm) below the mark on the wall 2. Include rider weight on the seat when measuring.
-
The adjustment screw is located on the right side of the work light pod. To adjust the beam, loosen the screw. Adjust the headlamp to the desired position, then tighten the screw.