Starting the Engine
Never start the engine before performing the Pre-Ride Check. See Pre-Ride Check and Pre-Ride Check.
-
Pull the engine stop switch up to the RUN position.
-
Do not use the choke when starting a warm engine. If the engine is cold, pull the choke lever completely out to the FULL ON position.
CAUTIONDo not apply throttle while starting. -
Grasp the starter handle and pull slowly until the recoil engages, then pull abruptly to start the engine.
NOTICEExtending the starter rope too far or allowing it to snap back into the housing will cause damage to the recoil assembly. Do not extend the starter rope to its maximum length, and do not drop the rope handle during starting. -
If the engine slows or stops, position the choke knob half way in.
-
Apply the brakes and vary the engine RPM slightly with the throttle to aid in warm-up. When the engine idles smoothly, push the choke knob all the way in.
NOTICETo prevent excessive wear on the clutch components, don't engage the clutch while performing the warm-up.