en
IMPORTANT

The Owner's Manual for this vehicle contains warnings, instructions and other information you must read and fully understand before safely riding or performing maintenance on this vehicle. Always follow the warnings and instructions in Owner's Manual.

Click the link above for the Table Of Contents, or download a full PDF of the Owner Manual in the Owner Support area of Polaris.com.

Headlight Housing Replacement
(570 / 570 EPS / X2)

  1. Remove the two screws on the lower front corners of the headlight pod.

  2. Lift the pod slightly while depressing the tabs at the rear of the pod.

  3. Lift the pod cover and disconnect the speedometer harnesses from the speedometer.

  4. Unplug the headlamp from the wiring harness.

  5. Use a small screwdriver to remove the o-rings from the headlight mounting tabs.

  6. Pull the headlight housing up to release it from the locking tabs.

  7. Lift the adjusting knob up to remove it from the locking tabs.

  8. Carefully pull the assembly up and out of the pod.

  9. Reverse the steps to install the new housing and reassemble the pod. The distance from the headlamp parting line to the end of the adjustment knob stop is 13 cm (5 1/8”) 1.

  10. Adjust the headlight aim by turning the adjustment knob.

Parent topic: Lights