en
IMPORTANT

The Owner's Manual for this vehicle contains warnings, instructions and other information you must read and fully understand before safely riding or performing maintenance on this vehicle. Always follow the warnings and instructions in Owner's Manual.

Click the link above for the Table Of Contents, or download a full PDF of the Owner Manual in the Owner Support area of Polaris.com.

Rider Information Center

The rider information center is located in the instrument cluster. All segments will light up for one second at start-up. If the instrument cluster fails to illuminate, a battery over-voltage may have occurred and the instrument cluster may have shut off to protect the electronic speedometer. If this occurs, your dealer can provide proper diagnosis.

The information center is set to display standard units of measurement and a 12-hour clock at the factory.


1 Gear Indicator This indicator displays gear shifter position.
2 Fuel Gauge The segments of the fuel gauge show the level of fuel in the fuel tank. When the last segment clears, a low fuel warning is activated. All segments including the fuel icon will flash. Refuel immediately.
3 Information Display Area This area displays the following mode options in this order: odometer, trip meter, tachometer, engine temperature, engine hour meter, service hour interval, and error codes. Cycle through these modes using the mode button. When the vehicle is restarted, this area will display the last mode you were using, rather than starting over at the odometer.
4 Battery Under / Over Voltage This warning indicates the vehicle is operating at an RPM too low to keep the battery charged or if the engine is at idle and a high electrical load (lights, cooling fan, accessories) is applied.
Lo [VOLTAGE] – Battery voltage is too low (below 11V). Drive at a higher RPM or recharge the battery to clear the warning.
Ov [VOLTAGE] – High electrical load has been applied to the battery (above 15V) or there is a possible issue with another vehicle component. Contact your dealer for assistance.
5 Clock The clock displays time in a 12-hour or 24-hour format.
6 Service Indicator A flashing wrench symbol alerts the operator that the preset service interval has been reached. Refer to the Periodic Maintenance Chart section to view what service needs to be carried out at your current service interval.
7 4x4 Indicator This indicator illuminates when the vehicle is in gear and AWD is engaged (switch is on 4x4, AWD or ADC 4x4). There is no indicator for the 2WD setting.
8 Turf Mode Indicator
(if equipped)		 This indicator illuminates when the operator unlocks the differential. Refer to the All Wheel Drive/Rear Differential System section for more info on unlocking the differential.