Ski Toe Settings
The skis on your snowmobile are set with a small amount of toe-out at the factory. You can inspect the toe setting by following the procedure below.
| Ski Toe Measurement Table | ||
|---|---|---|
| Model | Skis Off Ground (Yes/No) | Difference Between 1 and 2 Measurements | 
| 550 INDY 144 550 INDY LXT 550 INDY Voyageur 550 INDY ADVENTURE  | 
                     
                     Yes | 0-1/8 in. (0-3 mm)  | 
                     
| 550 INDY Voyageur 155 550 INDY ADVENTURE 155  | 
                     
                     No | 1/8-1/4 in. (3-6 cm)  | 
                     
| INDY 121 | Yes | 0-1/8 in. (0-3 mm)  | 
                     
| INDY EVO EVO RMK  | 
                     
                     Yes | 5/16-3/8 in. (8-9.5 mm)  | 
                     
- 
               
               
On some models, measuring ski toe must be done with the skis off the ground. Refer to the ski toe measurement table above.
 - 
               
               
If your model requires lifting the skis off the ground, safely elevate the front end of the snowmobile using a floor jack.
 - 
               
               
If your model does not require lifting the skis, make sure only vehicle weight is compressing the suspension when measuring.
 - 
               
               
Place the handlebars in a straight-ahead position.
 - 
               
               
Measure 10 inches (25.4 cm) forward from the center of the ski mounting bolt3. At this point, measure between the skis. This is measurement 1.
 - 
               
               
Perform the same measurement rearward from the center of the ski mounting bolt. This is measurement 2.
 - 
               
               
The 1 measurement should be greater than the 2 measurement by the amount shown in the ski toe measurement table. If the skis are misaligned, or if ski toe requires adjustment, your dealer can assist.