en
IMPORTANT

The Owner's Manual for this vehicle contains warnings, instructions and other information you must read and fully understand before safely riding or performing maintenance on this vehicle. Always follow the warnings and instructions in Owner's Manual.

Click the link above for the Table Of Contents, or download a full PDF of the Owner Manual in the Owner Support area of Polaris.com.

Proper Seat Belt Use

  • This vehicle is equipped with three-point lap and diagonal seat belts for all occupants. Always make sure the seat belts are secured for operator and all passengers before operating.

  • When the key is turned on, the seat belt indicator lamp will illuminate if the driver’s seat belt is not fastened.

  • To wear the seat belt properly, follow this procedure:

  1. Pull the seat belt latch plate 1 downward and across your chest toward the buckle 2 at the inner edge of the seat.

  2. Slide the latch plate up the webbing as far as needed for the belt to reach across your hips. The belt should fit snugly across your hips and diagonally across your chest. Make sure the belt is not twisted.

  3. Push the latch plate into the buckle until it clicks.

  4. Release the strap, it will self-tighten.

  5. To remove slack in the lap belt portion of the belt, pull upward on the shoulder belt. To loosen the lap belt if it is too tight, tilt the buckle and pull the lap belt slightly longer.

  6. To release the seat belt, press the square red button 3 in the buckle’s center. If necessary, slide the buckle down the webbing to allow it to retract fully.

Parent topic: Seat Belts