en
IMPORTANT

The Owner's Manual for this vehicle contains warnings, instructions and other information you must read and fully understand before safely riding or performing maintenance on this vehicle. Always follow the warnings and instructions in Owner's Manual.

Click the link above for the Table Of Contents, or download a full PDF of the Owner Manual in the Owner Support area of Polaris.com.

Fuel Filter / Water Separator

The fuel filter/water separator is located under the seat on the left side of the vehicle, between the engine and fuel tank.

Inspect the separator daily for leaks. Drain water and replace the separator at the intervals outlined in the Periodic Maintenance Chart. Service the separator more frequently if the vehicle is operated with inferior fuel.

CAUTION
Both fuel and water will drain from the separator during the following procedure. Use caution and observe all fuel safety precautions when handling fuel.

  1. Remove the seat. Disconnect the battery.

  2. Place an appropriate container under the fuel filter drain to catch fluids (water and fuel).

  3. Slightly loosen the bleed screw to relieve fuel pressure in the filter. Do not tighten the screw at this time.

  4. Reach under the fuel filter and slightly loosen the drain valve 1 until the fluids drain from the drain hole. Do not completely unscrew the drain valve.

  5. When fluids stop draining from the valve, tighten the valve firmly (by hand only).

  6. Reconnect the battery.

  7. Turn the ignition key on to engage the fuel pump. Leave the key on only until fuel begins to spit from the bleed screw 2, then tighten the screw.

  8. Clean up any spilled fuel and soiled shop towels properly.

  9. Cycle the key switch from OFF to ON six times, waiting three seconds at each “ON” cycle to allow the fuel pump to cycle.

  10. Start the engine and check for fuel leaks.

  11. Reinstall the seat.