Constant Variable Transmission (CVT) System
Failure to comply with the instructions in this warning can result in severe injury or death.
Do not modify any component of the CVT system. Doing so may reduce its strength so that a failure may occur at a high speed. The CVT system has been precision balanced. Any modification will cause the system to be out of balance, creating vibration and additional loads on components.
-
Always follow all recommended maintenance procedures. See your POLARIS dealer, or other qualified person, for service and repair assistance.
-
This CVT system is intended for use on POLARIS products only. Do not install it in any other product.
-
Always make sure the CVT housing is securely in place during operation.
CVT Drying
There may be some instances when water is accidently ingested into the CVT system. Use the following instructions to dry it out before operating. The drain plug is located on the bottom of the CVT cover.
-
Remove the drain plug. Allow the water to drain. Reinstall the drain plug.
-
Shift the transmission to neutral. Set the parking brake.
-
Start the engine. Apply varying throttle for 10-15 seconds to expel the moisture and air-dry the belt and clutches. Do not hold the throttle wide open for more than 10 seconds.
-
Allow the engine RPM to settle to idle speed.
-
Test for belt slippage. If the belt slips, repeat the process.
-
Your vehicle requires service as soon as possible. Your POLARIS dealer can assist.