en
IMPORTANT

The Owner's Manual for this vehicle contains warnings, instructions and other information you must read and fully understand before safely riding or performing maintenance on this vehicle. Always follow the warnings and instructions in Owner's Manual.

Click the link above for the Table Of Contents, or download a full PDF of the Owner Manual in the Owner Support area of Polaris.com.

Vehicle Will Not Operate

Possible Cause Solution
High-voltage battery pack not charged Charge the vehicle. See Charging Your Vehicle for details.
Key not properly engaged Ensure the key is fully inserted into the key switch and turned to the ON position
Low 12V battery voltage Recharge the battery pack. If problem persists, a replacement 12V battery may be necessary.
Loose 12V battery connections Check all connections and tighten
Required torque exceeds motor capability Apply the brakes and select low gear
High-voltage service disconnect removed Verify high-voltage service disconnect installed correctly. See Disconnecting High Voltage Power for details.
Vehicle in Charging Mode Verify EVSE charger is disconnected
Invalid gear position Shift vehicle to Park (P) and cycle Key Switch
PASS security system enabled Input correct security code. See PIN Activated Security System (P.A.S.S.) (if equipped) — Instrument Cluster for details.
Broken drive belt Contact your dealer for service.
Fault condition detected

  • See Diagnostic Trouble Codes if a fault code appears on the instrument cluster or display screen (if equipped).

  • Water may be present in the vehicle’s internal electrical components. Allow some time for drying before attempting to start.