Diagnostic Code

Diagnostic Code Screen will show available MIL that has come on during that ignition cycle.

To access the Diagnostic Code Screen, do the following:

1. Press and hold the MODE button to enter the Options Menu. “OPTIONS” will display on the screen for 3 seconds before showing first menu item.

1. Select “Diagnostic Codes” from the Options Menu by pressing the MODE button.

   Toggle the Up/Down Buttons to cycle through Code(s).

   NOTICE

   This option will only be available if a fault code was set or is active during the current ignition key 'on' cycle. Turning off the ignition will clear any save fault codes from the gauge.

   • 1 Display area 1 will show FMI

   • 2 Display area 2 will show SPN

   • 3 Clock Area will show Count.

   

   NOTICE

   When the gauge is displaying a fault code, the warning telltale (check engine or EPS) will blink to indicate which controller set the fault code.

2. To exit the Options Menu the user can select Exit Menu function from Options Menu, can hold Mode Button and exit out of Options Menu, or not press any button for 10 seconds, which will exit out of the Options Menu.