en
IMPORTANT

The Owner's Manual for this vehicle contains warnings, instructions and other information you must read and fully understand before safely riding or performing maintenance on this vehicle. Always follow the warnings and instructions in Owner's Manual.

Click the link above for the Table Of Contents, or download a full PDF of the Owner Manual in the Owner Support area of Polaris.com.

Headlight Aim Inspection

NUMBER DESCRIPTION
1 Measure Distance = 4 in (10.2 cm) (to the top cutoff of the low beam)
2 Measure Distance = 32 ft 10 in (10.0 m)
3 Headlight Center
NOTICE
Adjust headlight aim when there is a change in load (rider, cargo, accessories, etc.) or after suspension adjustment.

  1. Verify that the tire pressures are at specification.

  2. Verify that rear suspension ride height (preload) is at specification.

  3. Position the motorcycle on a level surface with the headlight 32 ft 10 in (10.0 m) from a wall.

  4. With the operator and passenger (if applicable) on board, bring the motorcycle to the fully upright position.

Horizontal Adjustment:

  1. Start the engine and switch the headlight to high beam. Observe the headlight aim on the wall.

  2. Make any necessary adjustments to center the brightest portion of the high beam straight ahead.

Vertical Adjustment:

  1. Switch the headlight to low beam. Observe the headlight aim on the wall.

  2. Make any necessary adjustments to headlight aim per the diagram table.