High Beam Adjustment
The headlight beam can be adjusted slightly upward or downward. Use the following procedure to make the adjustment.
-
Position the vehicle on a level surface with the headlight approximately 7.6 m from a wall 1.
-
Place the transmission in PARK.
-
Measure the distance from the floor to the center of the headlight and make a mark on the wall at the same height.
-
Start the engine. Turn the headlight switch to high beam.
-
Observe the headlight aim on the wall. The most intense part of the headlight beam should be 5 cm below the mark on the wall2. Include rider weight on the seat when measuring.
-
If adjustment is needed, the adjustment screw 1 is located on the right side of the headlight pod. To adjust the beam, loosen the screw. Adjust the headlamp to the desired position, then tighten the screw.
