en
IMPORTANT

The Owner's Manual for this vehicle contains warnings, instructions and other information you must read and fully understand before safely riding or performing maintenance on this vehicle. Always follow the warnings and instructions in Owner's Manual.

Click the link above for the Table Of Contents, or download a full PDF of the Owner Manual in the Owner Support area of Polaris.com.

Spark Arrester

WARNING

Do not perform clean out immediately after the engine has been run, as the exhaust system becomes very hot. Serious burns could result from contact with exhaust components.

To reduce fire hazard, make sure that there are no combustible materials in the area when purging the spark arrestor.

Wear eye protection.

Do not stand behind or in front of the vehicle while purging the carbon from the spark arrestor.

Never run the engine in an enclosed area.Exhaust contains poisonous carbon monoxide gas.

Do not go under the machine while it is inclined.Set the hand brake and block the wheels to prevent roll back.

Failure to heed these warnings could result in serious personal injury or death.

The exhaust pipe must be periodically purged of accumulated carbon as follows:


Periodically clean the spark arrester to remove accumulated carbon.

  1. Place the transmission in PARK.

  2. Remove the arrester retaining bolt and nut 1.

  3. Remove the arrester from the end of the muffler 2.

  4. Use non-synthetic brush to clean the arrester screen. A synthetic brush may melt if the components are warm. If necessary, blow debris from the screen with compressed air.

  5. Inspect the screen for wear and damage. Replace a worn or damaged screen.

  6. Reinstall the arrester.

  7. Torque the bolt to specification.

TORQUE

7–9 ft. lbs. (10–12 Nm)