en
IMPORTANT

The Owner's Manual for this vehicle contains warnings, instructions and other information you must read and fully understand before safely riding or performing maintenance on this vehicle. Always follow the warnings and instructions in Owner's Manual.

Click the link above for the Table Of Contents, or download a full PDF of the Owner Manual in the Owner Support area of Polaris.com.

Washing the Vehicle

Keeping your POLARIS vehicle clean will not only improve its appearance but it can also extend the life of various components.

Water in the PVT system could cause the drive belt to become wet and slip in the clutches. Always avoid spraying water directly toward any intake pre-filters 1. If water does enter the PVT intake, follow the procedure on PVT Drying.

Certain products, including insect repellents and chemicals, will damage plastic surfaces. Do not allow these types of products to contact the vehicle.

The best way to clean your POLARIS vehicle is with a garden hose and a pail of mild soap and water.

  1. Use a professional-type washing cloth, cleaning the upper body first and the lower parts last.

  2. Rinse with clean water frequently.

  3. Dry surfaces with a chamois to prevent water spots.

Washing Tips

  • Avoid the use of harsh cleaners, which can damage the finish.

  • Do not use medium to heavy duty compounds on the finish.

  • Always use clean cloths and pads for cleaning and polishing. Old or reused cloths and pads may contain dirt particles that will scratch the finish.

  • Do not use high-speed polishers/buffers on body panels, as damage or color fading may occur.

USING A HIGH PRESSURE WATER SYSTEM

If warning and safety labels are damaged, contact your POLARIS dealer for free replacement.

Grease all zerk fittings immediately after washing. Allow the engine to run for a while to evaporate any water that may have entered the engine or exhaust system.

If a high pressure water system is used for cleaning, exercise extreme caution. The maximum pressure should not exceed 3000 PSI, 2.5 GPM with a 40° pressure washer nozzle. Make sure to keep the pressure washer nozzle 2 ft from the vehicle away from the surface being cleaned. The water may damage components and could remove paint and labels. High water pressure may damage radiator fins and impair a radiator’s effectiveness. High pressure may also damage other vehicle components. Avoid directing the water stream at the following items:

  • Wheel bearings

  • Radiator

  • Transmission seals

  • Brakes

  • Cab and body panels

  • Labels and decals

  • Electrical components and wiring

  • Air intake components

  • Throttle and shift cables and controls

  • Seat Belts

  • Seats


WARNING
Spilled oil left on engine components or in the engine area may pose a fire hazard. Use shop rags to clean any spilled oil. If needed, use a non-flammable solvent on the rag to aid in the cleaning process. Do not use any device such as a pressurized water or air as this may disperse the oil onto engine components and could pose a fire hazard.
WARNING
Clean seat belts with warm water. Avoid damaging seat belts:

  • Do not use bleach, dye or household detergents.

  • Never use lubricant on any seat belt component.

  • Do not use a pressure washer to clean the seat belts.

Parent topic: Cleaning and Storage