en
IMPORTANT

The Owner's Manual for this vehicle contains warnings, instructions and other information you must read and fully understand before safely riding or performing maintenance on this vehicle. Always follow the warnings and instructions in Owner's Manual.

Click the link above for the Table Of Contents, or download a full PDF of the Owner Manual in the Owner Support area of Polaris.com.

Vehicle Immersion

NOTICE

If your vehicle becomes immersed, major engine damage can result if the machine is not thoroughly inspected. Take the vehicle in for service before starting the engine. Your POLARIS dealer can provide this service.

If it’s impossible to take your vehicle to a dealer before starting it, follow the steps outlined below. This procedure will allow for short-term operation only to drive the ATV to a trailer or towing vehicle.

  1. Move the vehicle to dry land or, at minimum, to water below the footrests.

  2. Turn the fuel valve off.

  3. Check the air box for any water and dry if water is present.

  4. Remove the spark plug.

  5. Loosen the carburetor drain screw.

  6. Turn the engine over several times using the electric start.

  7. Dry the spark plug and reinstall it, or install a new plug.

  8. Tighten the carburetor drain screw.

  9. Turn the fuel valve on.

  10. Attempt to start the engine. If necessary, repeat the drying procedure.

  11. Take the vehicle in for service as soon as possible, whether you succeed in starting it or not. Your POLARIS dealer can provide the required service.

  12. If water has been ingested into the transmission, follow the procedure in the Constant Variable Transmission (CVT) System section for details on drying the CVT.