en
IMPORTANT

The Owner's Manual for this vehicle contains warnings, instructions and other information you must read and fully understand before safely riding or performing maintenance on this vehicle. Always follow the warnings and instructions in Owner's Manual.

Click the link above for the Table Of Contents, or download a full PDF of the Owner Manual in the Owner Support area of Polaris.com.

Toe Alignment

Use the following procedure to check the toe alignment of the vehicle. The recommended toe alignment is 1/8 to 1/4 inch (3-6 mm) toe out.

WARNING
Severe injury or death can result from improper toe alignment and adjustment. Do not attempt to adjust tie rod alignment. All tie rod adjustments should be performed by an authorized POLARIS dealer.

  1. Position the vehicle on a level surface.

  2. Set the handlebars in a straight-ahead position and secure them in this position.

  3. Place a chalk mark on the center line of both front tires 2 approximately 10 inches (25.4 cm) from the floor, or as close to the hub/axle center line 1 as possible. Make sure both marks are the same distance from the floor.

  4. Measure the distance between the marks and record the measurement.

  5. Move the vehicle until the chalk marks are at the rear of the tires 3, even with the hub/axle center line.

  6. Measure the distance between the marks and record the measurement.

  7. Subtract the second measurement from the first measurement. The difference is the vehicle toe-out alignment.

  8. If you discover improper alignment, see your dealer for service.