en
IMPORTANT

The Owner's Manual for this vehicle contains warnings, instructions and other information you must read and fully understand before safely riding or performing maintenance on this vehicle. Always follow the warnings and instructions in Owner's Manual.

Click the link above for the Table Of Contents, or download a full PDF of the Owner Manual in the Owner Support area of Polaris.com.

Lubrication — Driveshaft and Shifter

There are 3 grease zerks located on the driveshafts 1, and one on the transmission shifter 2. Before greasing, make sure to clean each zerk to avoid dirt contamination.

Front Driveshaft

To reach the front driveshaft grease zerk 1:

  1. Remove the 11 fasteners 3 and driveshaft tunnel. Two additional fasteners are located under the middle seat, and one fastener in the front.

  2. Spin the driveshaft till the grease zerk is exposed.

  3. Clean the grease zerk. Add 2 squeezes of grease.

Midshaft

To reach the midshaft grease zerk 1:

  1. Remove the mid vehicle skid plate.

  2. Spin the driveshaft till grease zerk is exposed.

  3. Clean the grease zerk. Add 2 squeezes of grease

Rear Driveshaft

To reach the rear driveshaft grease zerk 1:

  1. Find the rear driveshaft grease zerk through the drivers side rear wheel well.

  2. Spin the driveshaft till grease zerk is exposed.

  3. Clean the grease zerk. Add 2 squeezes of grease

Shifter Linkage

To reach the shifter grease zerk 2:

  1. Find the shifter grease zerk through the drivers side rear wheel well.

  2. Clean the grease zerk. Add 2 squeezes of grease

Parent topic: Lubrication Recommendations