Handlebar Component Fastener Torques
IMPORTANT
Moving a handlebar component without first loosening its screws/set screws may cut grooves into the handlebar, making it difficult to secure the component. Do not move a handlebar component without first loosening its mounting screws/set screws. Take care to avoid damaging hand warmer/brake switch wires when moving components.
|
Component |
Torque Do not over-tighten |
|
|---|---|---|
| 1 |
Upper / Lower Riser Clamps |
14.8 ft-lbs (20 N·m) |
| 2 |
Throttle Block Clamp Screw |
20 in-lbs (2.3 N·m) |
| 3 |
Engine Stop Switch Clamp Screw |
20 in-lbs (2.3 N·m) |
| 4 |
Brake Lever / Master Cylinder |
70 in-lbs (7.9 N·m) |
| 5 |
Left Hand Control Block |
20 in-lbs (2.3 N·m) |
| Not Shown | Hand Guard Mounts (if applicable) | Hand-Tighten |