en
IMPORTANT

The Owner's Manual for this vehicle contains warnings, instructions and other information you must read and fully understand before safely riding or performing maintenance on this vehicle. Always follow the warnings and instructions in Owner's Manual.

Click the link above for the Table Of Contents, or download a full PDF of the Owner Manual in the Owner Support area of Polaris.com.

Oil Change (Cover Drain Method)

  1. Position the snowmobile on a level surface.

  2. Remove the two (2) screws securing the fender to the chaincase 1.

  3. Remove the right side panel. If equipped with a battery, remove the battery.

  4. Place a drain pan under the chaincase.

  5. Loosen (do not remove) the three (3) chaincase cover screws 2.

  6. Carefully pry the cover open.

    NOTICE

    DO NOT insert a screwdriver or pry bar between the cover and chaincase. Seal damage may occur.

  7. Allow the oil to drain completely.

  8. Tighten the cover screws 2 to specified torque.

    TORQUE

    Cover Screws

    6-10 ft-lbs (8-13 N·m)

  9. Remove the fill plug 3. Clean all metal shavings off the plug.

  10. Using a funnel, slowly add the recommended oil until the fluid begins to overflow. Maximum fluid capacity is 10.5 oz. (310 ml).

  11. Clean the area with a clean, dry shop towel.

  12. Reinstall the fill plug 3.

    TORQUE

    Oil Fill Plug

    4-4.9 ft-lbs (5.4-6.6 N·m)

  13. Reinstall the battery (if equipped).

  14. Reinstall the screws securing the fender to the chaincase.

Parent topic: Chaincase Oil (if equipped)