Cleaning the Snowmobile

Snowmobiles, especially those transported on sled decks and open trailers can accumulate a lot of water and road dirt / salt during the riding season. The snowmobile must be thoroughly washed and cleaned to prevent corrosion and rust formation.

Cleaning any Polaris snowmobile should ONLY be done with a mild soap and water solution. Any cleaning, buffing or waxing products containing colorant dye should be avoided. If using products with colorant dye in them, test on an inconspicuous area of the bodywork before applying, as a dye may stain the finish.

1. Wash the snowmobile with mild soap and water. Note that if a pressure washer is used, care should be taken to not point the pressure washer nozzle close to the snowmobile, which may force high pressure water into suspension / shock shaft seals and exposed electrical connectors.

2. Dry the snowmobile with a lint-free towel. Allow the entire snowmobile to air dry afterwards.

3. Clean the engine compartment. Use a shop vacuum if required to remove dirt, leaves, cat tails, etc. from within the engine compartment.

4. If choosing to apply a cleaner, wax or polish, make sure it does not contain a colorant dye and/or test on an inconspicuous area of the panel. Also make sure the product is safe to use on Molded Nylon 6 material with or without a painted finish.

5. Hand wash the exhaust system and dry the pipe and silencer with a clean shop towel.

6. Apply “spray” metal protectant on exposed metal components, such as the exhaust pipe, silencer, shock shafts, and suspension springs / pivots.

   IMPORTANT

   Do not spray metal protectant on the drive or driven clutches.

Molded Nylon 6 Body Panels

IMPORTANT

The use of a high speed/orbital polisher/buffer is not recommended on Molded Nylon 6 components and could result in color fading.

Reference Number	Description
1	Hood Trim, LH and RH
2	Console Trim, LH and RH
3	Side Panel Trim, LH and RH
4	Side Panels, LH and RH
5	Hood